7
Receiving
1. Remove contents from the shipping box.
2. Inspect contents for shipping damage and report damage, if any, to your distributor.
3. Be sure to keep the box and packing material should you need to pack the lathe for moving.
4. Exposed metal surfaces on the lathe have been factory-treated with a protectant, and should be
cleaned with a soft rag. Do not clean the lathe with anything other than a damp cloth or a mild solvent.
Use of heavy solvents, paint thinner, gasoline, etc. will damage painted surfaces.
Contents of the Shipping Carton:
JML-1014VSI (708375VS) JWL-1220VS (708376VS)
1 – Lathe with motor and tailstock 1 – Lathe with motor and tailstock
1-Control Box (with 2 screws) 1-Control Box (with 2 screws)
1 – 6” Tool rest 2 – Tool rests (6”,10”)
1 – Face plate 1 – Face plate
1 – Knockout rod 1 – Knockout rod
1 – Live center 1 – Live center
1 – Spur center 1 – Spur center
1 – Safety goggles 1 – Safety goggles
1 – Owner’s manual 1 – Tool caddy
1 – Warranty card 1 – Work lamp (bulb
1 – 3mm hex wrench not included)
1 – 5mm hex wrench 1 – Owner’s manual
1 – Warranty card
1 – 3mm hex wrench
1 – 5mm hex wrench
To Next Page
Loading...
Need help?
General
