EasyManuals Logo

Jet JML-1014VSI User Manual

Jet JML-1014VSI
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
Operation
Tailstock Handwheel (A, Figure 2) - Turn clockwise to move tailstock spindle forward. Turn counter-
clockwise to retract tailstock spindle.
Tailstock Spindle Lock (B, Figure 2) - Locks tailstock spindle. Release to adjust with handwheel.
Tailstock Lock (C, Figure 2) - Locks tailstock in position on the bed. Release to move tailstock assembly
closer to or farther from the headstock.
The tailstock spindle is hollow. This can be useful for inserting a long bit to drill a hole in the center of a
workpiece on the faceplate.
The clamping device on the tailstock has been factory adjusted; however if further adjustment should be
needed, slide the tailstock off the end of the bed, and tighten or loosen the nut (D, Figure 3) beneath the
tailstock.
Work Lamp (JWL-1220 only)
The 20” lathe is provided with a flexible work lamp which uses a 40-watt bulb (not provided). Position the
work lamp so that wood chips do not accumulate inside the lamp shade and pose a fire hazard.
Use only a 40-watt or smaller bulb in the work lamp.
Figure 2
Figure 3

Other manuals for Jet JML-1014VSI

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jet JML-1014VSI and is the answer not in the manual?

Jet JML-1014VSI Specifications

General IconGeneral
BrandJet
ModelJML-1014VSI
CategoryLathe
LanguageEnglish

Related product manuals