3
29. Check damaged parts. Before further use of
machine, a guard or other part that is damaged
should be carefully checked to determine that it
will operate properly and perform its intended
function. Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or
replaced.
30. Keep floor around machine clean and free of
scrap material, oil and grease.
31. Keep visitors a safe distance from work area.
Keep children away.
32. Make your workshop child proof with padlocks,
master switches or by removing starter keys.
33. Give your work undivided attention. Looking
around, carrying on a conversation and “horse-
play” are careless acts that can result in serious
injury.
34. Maintain a balanced stance at all times so that
you do not fall into blade or other moving parts.
Do not overreach or use excessive force to
perform any machine operation.
35. Use the right tool at the correct speed and feed
rate. Do not force a tool or attachment to do a
job for which it was not designed. The right tool
will do the job better and more safely.
36. Use recommended accessories; improper
accessories may be hazardous.
37. Maintain tools with care. Keep blades sharp and
clean for best and safest performance. Follow
instructions for lubricating and changing
accessories.
38. Turn off machine before cleaning. Use a brush
or compressed air to remove chips or debris —
not your hands.
39. Do not stand on machine. Serious injury could
occur if machine tips over.
40. Never leave machine running unattended. Turn
power off and do not leave band saw until blade
comes to a complete stop.
41. Remove loose items and unnecessary work
pieces from area before starting machine.
42. Keep hands out of path of saw blade. Do not
reach around a moving saw blade.
43. Don’t use in dangerous environment. Do not
expose machine to rain or use in wet or damp
locations. Keep work area well lighted.
44. Make sure band saw is securely fastened to
base.
45. Do not start the band saw with a workpiece in
contact with the blade.
46. Allow blade to reach full speed before cutting.
47. Keep blades clean and sharp. Do not use
blades that are cracked, poorly welded, or have
missing or deformed teeth.
48. Use a push stick or other safety device when
ripping narrow workpieces.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible
machine damage.
This means that if precautions are not heeded, it may result in serious, or possibly even fatal,
injury.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
Need help?
General
