Fig 52
JET part number: JWBS15-1125
The table insert may not project above table surface.
Saw blades:
The servicing of sawblades should only be performed by a
trained person.
Only use sharp and properly set sawblades.
Lubrication points:
Periodically apply a light all-purpose grease to rack and pinion
(Fig 53).
Fig 53
To the table trunnions (Fig 54).
Fig 54
To the blade tension screw (Fig 55).
Fig 55
Note:
Bearings on the band saw are pre lubricated and sealed and
do not require attention.
9. Trouble shooting
Motor doesn’t start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload has reacted-
Wait and start again.
*Wheel covers not closed-
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*dust on wheel-
clean tires.
*sawblade has cracks-
replace sawblade immediately
Cut is not square
*Table stop setting wrong.
*Blade guide setting is bad
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*Blade guide setting is bad
*Blade tension too low
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
To Next Page
Loading...
Need help?
General
