21
Figure 32
10. Remove belt through lower access door.
11. Reverse above procedure to install belt and re-
position spindle.
NOTE: Make sure to insert spindle lock with its
spring before tightening cover. Do not
overtighten spindle handwheel when installing.
13.0 Recommended Lathe Speeds
(per diameter of workpiece)
Diameter of Work Roughing RPM General Cutting RPM Finishing RPM
Under 2” 1520 3000 3000
2” to 4” 760 1600 2480
4” to 6” 510 1080 1650
6” to 8” 380 810 1240
8” to 10” 300 650 1000
10” to 12” 255 540 830
12” to 14” 220 460 710
14” to 16” 190 400 620
16” to 20” 175 325 500
20” to 24” 175 260 400
Table 2
To Next Page
Loading...
