9
Uncrating and Clean-Up
Note: Uncrating and assembly will require two
people due to the machine’s size and weight.
1. Finish removing contents from the shipping
crate. Be sure to check crate thoroughly for
any parts not found on initial unpacking.
2. Inspect contents for shipping damage and
report any damage to your distributor.
3. Clean all protected parts with kerosene. Do
not use gasoline, paint thinner, or any other
cellulose-based solvent. These will damage
painted surfaces and melt plastic.
Contents of Shipping Carton:
1 Lathe Bed with Motor and Tailstock
1 12-inch Tool Rest with Extension
4 Stand Legs
2 Long Stand Braces
2 Short Stand Braces
2 Stand Tops
1 Bed Extension
1 Headstock Handwheel
1 6-inch Face Plate
1 Drift Rod
1 Live Center
1 Spur Center
2 Index Pins
1 Safety Goggles
1 Hardware Package (nuts, bolts, etc.)
1 Operator’s Manual
1 Warranty Card
Tools Required for Assembly
No. 1 cross point screwdriver
No. 1 flat blade screwdriver
Hex wrench set
Adjustable wrench or combination wrench set
Use of sockets and a ratchet will speed stand
assembly but are not required.
To Next Page
Loading...
