10
Assembly
Note: Assemble stand completely and mount
bed to stand before tightening all nuts. Hand
tighten only during this part of the assembly
process.
Referring to Figure 1:
1. Attach a stand top (A) to a stand leg (B) with
three 5/16”x1” carriage bolts (C), three 5/16”
flat washers (D), three 5/16” lock washers
(E), and three 5/16" hex nuts (F). Stand top
must be placed inside stand leg.
2. Attach second stand leg to previous
assembly in the same manner.
3. Repeat these steps with the remaining two
stand legs and stand top.
4. Join the two leg assemblies by attaching
long braces (G) to each leg and fastening
with eight 5/16”x1”carriage bolts (C), eight
5/16” flat washers (D), eight 5/16” lock
washers (E) and eight 5/16” hex nuts (F).
Remember to hand tighten only at this time.
5. Attach short braces (H) to each end of the
stand using four 5/16”x1” carriage bolts (C),
four 5/16” flat washers (D), four 5/16” lock
washers (E), and four 5/16” hex nuts (F).
6. Place assembled stand in approximate final
location that is solid and level.
7. With the help of a second person, carefully
lift bed up and onto stand.
Note: Be sure to place headstock end on
the stand end with the switch.
Note: Before setting bed assembly down on
the stand top, run motor cord through the
hole in the stand top.
Figure 1
To Next Page
Loading...
