Jet JWL-1442VS - Wood Lathe Specifications; JWL-1442 VS Specifications

8
Specifications JWL-1442VS
Stock Number.................................................................................................................................708358
Over Bed..............................................................................................................................................14"
Swing Over Tool Rest Base..................................................................................................................10"
Distance Between Centers ...................................................................................................................42"
Speeds (RPM)......................................................................450, 600, 850, 1100, 1500, 1900, 2300, 3000
Spindle Nose...........................................................................................................................1" x 8 T.P.I.
Drive Spindle Through Hole................................................................................................................. 3/8"
Tailstock Spindle Through Hole ........................................................................................................... 3/8”
Tailstock Spindle Travel.......................................................................................................................... 4”
Tool Rest.............................................................................................................................................. 12”
Face Plate.............................................................................................................................................. 6”
Headstock Rotation .................................................................................. 45°, 90°, 135°, 180°, 270°, 360°
Headstock Taper ...............................................................................................................................MT-2
Tailstock Taper..................................................................................................................................MT-2
Spindle Center to Floor (approx.).................................................................................................... 43-1/2”
Motor......................................................................................................................................... 1 HP, 1Ph
....................................................................................................................... 115V/230V, Prewired 115V
Net Weight (approx.).....................................................................................................................200 Lbs.
Shipping Weight (approx.) ............................................................................................................215 Lbs.
708358K Shown
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, WMH Tool Group reserves the right to change specifications at any time and
without prior notice, without incurring obligations.