How to make the blade go beneath the table surface on my Jet JWTS-10JF Saw?
If the blade of your Jet Saw will not go beneath the table surface, the table top might be too low, so raise the table top with washers.
Why won't the hand wheels on my Jet JWTS-10JF turn?
If the hand wheels on your Jet Saw won't turn, it could be because the hand wheel key is inserted too far, so remove the hand wheel and adjust the key. Alternatively, the bullets might be wedged, so remove the hand wheel and adjust the bullets. Another potential cause is that the roll pin or setscrew in the worm gear is contacting the geared trunnion, so inspect the roll pins and setscrews in the worm gear and tighten if necessary.
Details WMH Tool Group's limited warranty terms, exclusions, and procedures for claims. Covers defects in materials and workmanship.
Lists essential safety rules for the operator including attire, attention, and safe practices.
Lists detailed technical specifications of the JWTS-10JF table saw including dimensions, power, and blade capacity.
Step-by-step guide for assembling the table saw stand using provided hardware.
Steps for installing and aligning the blade guard and splitter assembly.
Details wiring requirements, voltage conversion, and safety checks for connecting the saw to power.
Instructions for adjusting the blade height and tilt mechanisms for desired cutting angles.
Explains causes of kickbacks and provides tips to minimize or prevent injury from them.
To Next Page
General
