Jet M-708448 - Contents of the Shipping Container; Tools Needed for Assembly

7
Contents of the Shipping Container
1. Stand (front)
1. Stand (rear)
2. Stand (sides)
1. Extension Table Assembly
1. Extension Cover
1. Owner’s Manual
1. Warranty Card
1. Sanding Unit with Motor
1. Back Stop
1. Handle
1. Driver Wrench
1. Miter Gauge Assembly
1. Sanding Belt
1. Adjusting Wrench
1. Assembly Hardware:
Cabinet
1. Lock Knob (20mm Length)
2. Lock Knob (12mm Length)
1. Lock Knob (35mm Length)
4. Cabinet Pads
4. 5/16” x 5/8” Screws
22. 5/16” Flat Washers
12. 5/16” Hex Nuts
8. 5/16” x 5/8” Hex Cap Bolts
2. 5/16” x 1-1/4” Hex Cap Bolts
4. Larger O/D 5/16” Flat Washers
10. 5/16” Lock Washers
Extension Table
5. 1/4" x 5/8” Hex Cap Bolts
5. 1/4" Flat Washers
5. 1/4” Lock Washers
1. Bracket
1. 3mm Hex Wrench
Dust Chute
3. Pan Head Screws
Tools Needed for Assembly
2) 12mm Wrench or sockets
1) 10mm Wrench or sockets
1) Flat Head Screw Driver
1) Cross Point Screw Driver