EasyManua.ls Logo

JetCat P80 - Page 68

JetCat P80
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Lrn Speed Lo
Learn1s the slow flight speed.
If the AUX switch is momentarily placed in the SW0 position, the
current flight speed is assigned and recorded as the Min.AirSpeed
parameter.
WARNING: When the AUX switch is set in the SW0 position, the
model must be flying faster than 40 km/h, otherwise the turbine will
shut off.
Lrn Speed Hi
Learn the fast flight speed.
If the AUX switch is momentarily placed in the SW0 position, the
current flight speed is assigned and recorded as the Max.AirSpeed
parameter.
WARNING: When the AUX switch is set in the SW0 position, the
model must be flying faster than 40 km/h, otherwise the turbine will
shut off.
LIN-Speed Ctrl
Cruise Control modes with linear speed regulation to the throttle
stick position.
Flight speed is controlled between the values of the Min AirSpeed
(throttle stick in the minimum position) and Max AirSpeed (throttle
stick in the maximum position).
3-StepSpdCtrl Cruise Control mode, featuring three different speeds.
Flight speed can be set to three predetermined speeds, between
the values of Min AirSpeed (throttle stick in the minimum position)
and Max AirSpeed (throttle stick in the maximum position).
Speed 1: Min AirSpeed Æ throttle stick in the minimum to 1/3
rd
position
Speed 2: (Min AirSpeed + Max AirSpeed) / 2 Æ throttle stick in
the
1/3
rd
to 2/3
rd
position
Speed 3: Max AirSpeed Æ throttle stick in the 2/3
rd
to maximum
position
Reminder:
The turbine can be immediately switched off, any time the throttle stick and the throttle
trim are brought to their minimum positions.
If Hold-Speed or Cruise Control modes are activated, while the model is flying over 40
km/h -- and should the model then slow down, to a speed less than 40 km/h -- Hold-
Speed or Cruise Control will remain active. The turbine will NOT shut off, unless the
AUX switch is moved back to the SW1 position and then returned to Hold-Speed or
Cruise Control position.
WARNING:
Page 68/74

Table of Contents