Jetco Torque Tools ED SERIES - Page 10

Parameters
CR at end or ? CR at end Get: CR at end or ? CR at end Set: SFP,X or XX or XXX
9Jetco Torque Tools
Description
www.itorque.com
Get: CR at end or ? CR at end Set: SEA,X or XXX, = 0 to 360, 0 = OFF
LIST OF ASCII COMMANDS
ExmapleCommand
Get: Command: SET?<CR> or SET<CR> Response: Setpoint Value Set: Command: SET,50.0<CR> = Set Setpoint to 50.0 Response: OK
Get: CR at end or ? CR at end Set: SET,X or XXXXX
Get / Set SetpointSET
Command: BAT<CR> Response: Battery Level in percent full.
Get: Command: SFP?<CR> or SFP <CR> Response: First Peak setpoint in A/D counts Set: Command: SFP,300<CR> = Set First Peak setpoint to 300 counts. Range 1 to 999 counts. Response: OK Get: Command: SEA?<CR> or SEA <CR> Response: Angle Setpoint Value Set:
Command: SEA,5<CR> = Set Angle Setpoint to 5
degrees Response: OK
BAT SFP
SEA
SWO
Get Battery Level Get / Set First Peak A/D Count Get / Set Angle Setpoint Get / Set Auto Off Time
Get: CR at end or ? CR at end Set: SWO,X or XX
Get: Command: SWO?<CR> or SWO<CR> Response: Auto off time in minutes Set: Command: SWO,10<CR> = Set Auto off time to 10 minutes. Range 1 to 30 minutes. Response: OK