Jetco Torque Tools ED SERIES - List of ASCII Commands

LIST OF ASCII COMMANDS
Jetco Torque Tools www.itorque.com8
Command Description Parameters
MMV
Or '?' DMM
Get / Set Setpoint Percent
CR at end
Command: DMM?<CR> or DMM<CR> Response: All saved torque readings Command: RMM<CR> Response: OK Command: RDP<CR> Response: OK
Get: Command: PER?<CR> or PER<CR> Response: Setpoint Percent Value Set: Command: PER,5<CR> = Set Setpoint % to 5% Response: OK
Clear torque memory contents Clear display and peak Change display units to Newton Meters Return current torque value Return torque memory contents CR at end or ? CR at end Change display units to foot pounds Change display units to inch pounds
Exmaple
Command: LBF<CR> Response: OK Command: LBS<CR> Response: OK Command: NMT<CR> Response: OK Command: MMV?<CR> or MMV<CR> or ?<CR> Response: Torque value
CR at end CR at end CR at end or ? CR at end If '?' alone, no CR is needed
LBF
LBS
NMT
CR at end or ? CR at end CR at end Get: CR at end or ? CR at end Set: PER,X or XX, = 0 to 10 %, 0 = OFF
RDP
PER
RMM