www.itorque.com
CR at end
10Jetco Torque Tools
Power up in last saved mode.
LIST OF ASCII COMMANDS
ExmapleParametersDescriptionCommand
Get Version
Set display peak torque mode
Get:
Command: USR?<CR> or SWO<CR>
Response: User set ID, 24 characters maximum.
Set:
Command:
USR,123456789012345678901234<CR> = Set
user ID to ‘123456789012345678901234.
Response: OK
Please note any spaces after the comma will be
included.
Get: CR at end or ? CR at end
Set: USR,(User ID) CR at end
Get / Set User Wrench ID USR
VER
DPK
DAV
PFP
Set display average torque mode
Power up in first peak mode. CR at end
PLS
Command: VER<CR>
Response: Software Version Number
Command: DPK <CR>
Response: Software Version Number
Command: DAV <CR>
Response: Software Version Number
Command: PFP <CR>
Response: OK
Get: CR at end or ? CR at end
Get: CR at end or ? CR at end
Get: CR at end or ? CR at end
Command: PLS <CR>
Response: OK
To Next Page