COMPLEX RADIO CONTROL SYSTEM
EN
Computed - all receiver settings (e.g. Fail-Safe) are part of serial
communication
If the Fail Safe function is disabled,
there are no signals generated on
receiver outputs in case of signal loss,
either serial communication in "Direct"
mode. When the function is on, all
receiver outputs can be set individually
with the following options:
Repeat: the receiver at the output
keeps the last known value
Turn off the pin: the output is
disabled, no pulse is generated
Direct - all receiver settings (e.g. Fail-Safe) are not included in serial
communication
4.1.2 Fail-Safe
PPM/UDI (S.BUS) mode - method of processing data from the
transmitter
Low voltage alarm - setting the threshold for alarm activation
(power supply)
Fail-Safe: the output is set to the value specified in the "Value"
parameter.
Set fail-safe position now: when this option is activated, the
current values of the positions are set for all outputs set to "Fail-
Safe" mode.
Fail-safe delay: setting the time for which the system goes after
signal loss to Fail-Safe mode.
28
To Next Page
Loading...
Need help?
General
