COMPLEX RADIO CONTROL SYSTEM
Conformément à la réglementation d'Industrie Canada, le présent
émetteur radio peut fonctionner avec une antenne d'un type et d'un
gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le
type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante. This device
complies with the Industry Canada license-exempt RSS standard(s).
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OP E R ATIO N IS S UBJ E C T TO TH E FO L LOW I N G T WO
CONDITIONS(1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
Warning: Changes or modifications to this device not expressly
approved by Esprit Model/JETI USA could void the user’s authority to
operate the equipment. “This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This
equipment is in direct contact with the body of the user under normal
operating conditions. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.”
Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful communication.
EN
36
To Next Page
Loading...
Need help?
General
