JETI model duplex - Jeti Duplex Receiver Installation and Setup; Powering Duplex Receivers; Transmitter and Receiver Operation Sequence

COMPLEX RADIO CONTROL SYSTEM
3.1 Voltage supply
When designing the on-board wiring for your project, always pay
attention to the voltage input range of your receivers and servos.
You can connect supply voltage to the Duplex receivers as
follows:
- directly from the batteries
- via a BEC voltage regulator (either contained in speed
controllers or self contained)
The supply may be connected to the Duplex receivers via:
- the throttle channel (when applying speed controllers with BEC)
- a free receiver output.
- a Y-cable to any arbitrary receiver output (other than the
„Ext.“)
- the MPX connector for receivers with the EPC label or the R14
and R18 receivers which are equipped with a power supply
connector
3.2 Operation
We recommend that you switch on the transmitter first and then
subsequently the receiver. The transmitter confirms the switching-
on of the receiver with an acoustic signal. When switching off the
system we recommend that you switch off the receiver first and
then subsequently proceed with switching-off the transmitter.
3 Installation
EN
9