COMPLEX RADIO CONTROL SYSTEM
Some of the receivers outputs may be assigned (see the table of
receiver output assignments) to alternative functions. Description
of alternative functions:
- standard servo output - the throw of an actual channel is assigned
to the output that uses the standard servo output form and is
labelled CH xx.
- PPM off - for the given output there is no PPM signal generated or
received
- PPM input - for the given input there a PPM signal is expected from
the connected receiver
- PPM output - the receiver channel will generate a PPM signal
PPM error code- in case one of the SAT1/2 outputs is set to PPM
input mode, an acoustic signal can be set up to announce that this
connected signal is missing. By loading a character from the Morse
alphabet you may set up tones that will acoustically announce the
absence of a PPM signal at the given receiver output. This acoustical
signal is generated by the transmitter module. In the factory default
setup the acoustical signal is switched off.
SetInChannel - assignment of an actual output (labelled as Yx) or
input channel (labelled as Chx)
Signal Fault - setup of the receiver behaviour in case of signal loss,
„hold“- holds the most recent control throw, „out off“ – output
switch-off (no signal generated), „failSafe“ – moves to preset throws
for the individual outputs
EN
22
To Next Page
Loading...
Need help?
General
