COMPLEX RADIO CONTROL SYSTEM
27
The receiver can only be configured if the "motor shutdown
pulse" is not exceeded after connecting the power supply (default
setting 1,100 ms). Once a throttle pulse is exceeded, then the
receiver can no longer be set until its power supply is reset.
Settings can be made only by the DC/DS transmitter (in the
"device explorer" menu).
To display the R4 RES receiver in "device explorer", it is necessary to
have the configuration file R4RES.bin in the Devices folder in the
transmitter.
The measured data can be seen if the receiver is in the "Ready" or
"Done" status. The receiver save the data from the last
measurement and can be read again after connecting the power
supply. In the ready status, you can view the data from the last
measurement. Measurement data means the maximum relative
height reached during motor run and 10s after that and 10 relative
altitude values saved after 1s of motor run.
The receiver can be in the Ready status if the "motor shutdown
pulse" is not exceeded after connecting the power supply.
The receiver will be in the Running status if the throttle control
pulse exceeds the motor shutdown pulse level. After stopping the
motor the receiver goes from the Running status to the Measuring
status and evaluates the measurement for another 10s.
EN
To Next Page
Loading...
Need help?
General
