9629 Microprocessor Controller
- 54 -
MODEL 9629 WIRE FEEDER CONTROL
SCREEN
#
OPERATING MODE
MIN MAX DEFAULT
J e t l i n e E n g i n e e r i n g
H W
X X X . X i p m
X X X . X c p m
S T A R T D E L A Y X X . X s e c
S T O P D E L A Y X X . X s e c
W I R E R E T R A C T X . X s e c
R A M P T I M E X X . X s e c
X X X . X i p m
X X X . X c p m
3
4
5
6
M o l 9 6 2 9d e
P
1
W I R E S P E E D2
0.0
0.0
0.0
0.0
99.9
99.9
9.9
99.9
1.0
1.0
0.3
2.0
W I R E S P E E D7
These two lines display when the
control is rst switched on and
stay on for about 3 seconds, the
screen then automatically
advances to the next one.
Minimum and maximum values
are set during calibration.
This screen will be displayed
with the lower line message:
Adjustment Locked
Note:
If the Pulse Option is included, the letter “P” will follow the 9629 model number.
If the Hot Wire Option is included, the letters “HW” will follow the 9629 model number.
Screen 6 is only included when the 9629-HW option has been included in the control.
To Next Page
Loading...
Need help?
General