Jetline 9700W - Password, Backup, Restore, Hour Meter

Page 37
UNIPOLAR INPUT
Unipolar Input is either yes or no. If no, the input from the motor
can be both positive and negative voltage depending on direction.
If yes, the input voltage is always is always positive no matter
which direction the motor is running.
SUB MENU PASSWORD
If the right button is pressed, the user is allowed to see and
change the password for the calibration sub menu. If the
password is set to all blanks, then you do not need a password to
get into the sub menu. Use the dial to change the blinking
character and the right and left button to move to different
characters. To get out press the right button when at the far right
character. Password is always 5 characters.
BACKUP
If the right arrow is pressed the 9700W copies all of the calibration
parameters to the backup memory.
RESTORE
If the right arrow is pressed the 9700W copies all of the calibration
parameters from the backup to the main memory.
HOUR METER
Hour Meter shows how long the motor attached to the travel has
run. This is not weld time.
CALIB
NO
NO
llu
PASSWORD
SWITCH INPUT
UNIPOLAR INPUT
CALIB
NO
llu
llu
UNIPOLAR INPUT
PASSWORD
BACKUP
CALIB
llu
llu
llu
RESTORE
PASSWORD
BACKUP
CALIB
llu
llu
4
BACKUP
RESTORE
HOUR METER
CALIB
llu
4
llu
AUTO CAL
RESTORE
HOUR METER