Jetline 9700W - Units, Switch Motor;Jog, Unipolar Output;Input

Page 36
UNITS – INCH OR CM
Set the units for the system to either inch or CM (centimeters).
SWITCH MOTOR
Switch Motor is either no or yes. If yes, it switches the direction
on the motor to match the forward direction of the system.
SWITCH JOG
Switch Jog is either no or yes. If yes, it switches the direction of
travel jogging to help match the direction of the arrows on the
panel.
UNIPOLAR OUTPUT
Unipolar Output is either yes or no. If no, the output of the 9700-
10 board is from +/- 10 volts. If Yes, the output is 0 to 10 volts with
a relay contact for reverse.
SWITCH INPUT
Switch input is either yes or no. If no, the input voltage is not
switched in the software. If yes, it switches the polarity of the
input lines so that it reads a forward direction when moving
forward.
CALIB
0.219
INCH
NO
UNITS
SWITCH MOTOR
REMOTE LOW
CALIB
INCH
NO
NO
UNITS
SWITCH MOTOR
SWITCH JOG
CALIB
NO
NO
NO
SWITCH MOTOR
SWITCH JOG
UNIPOLAR OUTPUT
CALIB
NO
NO
NO
SWITCH INPUT
SWITCH JOG
UNIPOLAR OUTPUT
CALIB
NO
NO
NO
UNIPOLAR OUTPUT
SWITCH INPUT
UNIPOLAR INPUT