LOW IN
Low In is the voltage of the feedback from the motor when running
at the low limit. Minimum value is -1.000 and Maximum value is
100.000.
INPUT JUMPER
Input Jumper is J1, J2, or J3 and lets the system know which
jumper on the 9600-11R board is installed. J1 is for input voltage
of the tachometer up to 10 volts, J2 is for up to 33 volts and J3 is
for up to 100 volts.
SET SPEED
Set Speed is either local or remote. In local, the speed is
controlled by the panel. In remote, the speed is controlled by the
voltage between the remote input pins.
REMOTE HI
The voltage on the remote input pins that will cause the wire to go
at the high speed. Minimum value is 0.000 and Maximum value is
10.000.
REMOTE LOW
The voltage on the remote input pins that will cause the travel to
go at the low speed. Minimum value is 0.000 and Maximum value
is 10.000.
To Next Page
Loading...