Jetline 9700W - Password, Job Number, Firmware Version, Set DP

Page 40
PASSWORD, CONFIGURATION SUB MENU
Pressing the right button allows that user to see and change the
password for the configuration sub menu. If the password is set to
all blanks, then you do not need a password to get into the sub
menu.
JETLINE JOB NUMBER
Pressing the right button will show you the Jetline Job Number
that this control unit shipped out on. When the job number is
displayed you can press either the left or right arrow key to get
out.
FIRMWARE VERSION
Shows the version number of the firmware in your unit.
SET DECIMAL POINTS
Set DP is for the number of decimal points that can be displayed
when setting the travel speed. Minimum value is 1 and Maximum
value is 3.
BACKUP
If the right arrow is pressed, the 9700W copies all of the
configuration parameters to the backup memory.
CONFIG
llu
llu
llu
AUX3 NAME
PASSWORD
JOB NUMBER
CONFIG
llu
llu
1.000
PASSWORD
JOB NUMBER
VERSION
CONFIG
llu
1.000
1
JOB NUMBER
VERSION
SET DP
CONFIG
1.000
1
llu
VERSION
SET DP
BACKUP
CONFIG
1
llu
llu
SET DP
BACKUP
RESTORE