12
Lay a second row of :-
16”E / 16” - 5 coals 18” - 6 coals
This row of coals must lie behind the first row of coals previously laid and rest on the rear coal bed.
To achieve this it will be necessary to hold the first row of coals forward. When the second row of
coals are in place the first row of coals should now bridge between the front row of coals attached to
the front coal bed and this second row of coals. The first row of coals must not be pushed too far
forward so as to touch the rear of the fire front.
Lay a final row of :-
16”E / 16” - 4 coals 18” - 4 coals
This row of coals should lay behind the second row of coals previously laid. To achieve this it will be
necessary to hold the second row of coals forward so as this final row of coals can locate in the
valleys behind the second row of coals.
Ensure that once the coals have been laid there are even gaps between them. If a coal or coals
appear to fit awkwardly in certain positions then it may be necessary to swap these around with
others or relocate them by rotating to achieve an evenly spaced coal lay. This will ensure an even
flame spread when the fire is lit.
To Next Page
Loading...
Need help?
General
