16
2.4 Attaching the Handlebar
1. PROP THE UNFOLDED SCOOTER UP ON ITS KICKSTAND. (SEE
SECTION 3.6)
2. HOLD THE HANDLEBAR PIECE OVER THE STEM SO THAT THE
HANDLEBAR BASE IS ABOVE THE TOP OF THE STEM AND THE
HEADLIGHT IS FACING THE FRONT OF THE SCOOTER.
3. PLUG THE INSERTION COUPLER AT THE END OF THE WIRE IN
THE SCOOTER STEM INTO THE RECEIVING COUPLER AT THE
END OF THE WIRE IN THE HANDLEBAR.
4. CAREFULLY TUCK THE WIRING INTO THE STEM WHILE
LOWERING THE HANDLEBAR BASE INTO THE STEM.
5. IF NECESSARY, ROTATE AND ADJUST THE HANDLEBAR
SLIGHTLY UNTIL THE 4 HOLES IN THE HANDLEBAR BASE ARE
ALIGNED WITH THE 4 HOLES IN THE STEM—2 ON THE LEFT
SIDE OF THE SCOOTER AND 2 ON THE RIGHT.
IMPORTANT: PRIOR TO PROCEEDING, ENSURE THAT THE
COUPLERS ARE FULLY CONNECTED. FAILURE TO PROPERLY
CONNECT THE COUPLERS MAY CAUSE ELECTRICAL DAMAGE
OR SCOOTER MALFUNCTION.
IMPORTANT: TAKE CARE WHEN HANDLING ELECTRICAL COMPONENTS.
INSERTION
COUPLER
STEM
RECEIVING
COUPLER
HANDLEBAR BASE
HANDLEBAR BASE
WITH HARDWARE
HOLES
WIRING
STEM WITH
HARDWARE HOLES
To Next Page
Loading...
