Jetson Ora Pro - Page 21

MADE IN CHINA
DATE CODE: XX/XX
PART NUMBER: PJORAPR-CH
MANUFACTURED BY:
SHENZHEN HYLETON
TECHNOLOGY CO., LTD
CHARGER FOR USE WITH: ORA PRO
MODEL: HLT-180-4201500
INPUT: 100-240 VAC
50/60 Hz , 2.0A MAX
OUTPUT: DC 42.0V
⎓
1.5A IP20
E484089
CLASS 2 POWER SUPPLY
BEFORE CHARGING, READ THE INSTRUCTIONS.
WARNING: DO NOT EXPOSE TO WATER OR OTHER LIQUIDS
FOR INDOOR USE ONLY. DO NOT REMOVE THIS TAG.
19
THIS IS AN
EXAMPLE OF
THE MARKING
YOUR CHARGER
WILL HAVE.
IMPORTANT:
ONLY USE THE INCLUDED CHARGER OR ONE
OBTAINED DIRECTLY THROUGH JETSON
LABELED WITH HLT-180-4201500 MADE BY
SHENZHEN HYLETON TECHNOLOGY CO., LTD
OR CP4215 MADE BY POWSUN ELECTRONIC
CO., LTD (JETSON MODEL NO. PJORAPR-CH).
FAILURE TO USE CORRECT CHARGER CAN
RESULT IN FIRE AND EXPLOSION.
Important Charging Notes
• ALWAYS KEEP THE CHARGING PORT CLOSED WHEN NOT ACTIVELY CHARGING THE
BATTERY.
• NEVER TURN ON THE PRODUCT WHILE IT IS CHARGING.
• DO NOT USE RELOCATABLE POWER TAPS.
• FOR BEST BATTERY HEALTH, CHARGE THE BATTERY FULLY DURING EACH CHARGING
SESSION—ABOUT 4 HOURS.*
• NEVER LEAVE YOUR PRODUCT CHARGING OVERNIGHT OR FOR EXTENDED PERIODS
OF TIME.
• DO NOT ATTEMPT TO REMOVE OR DISASSEMBLE THE BATTERY.
• CHARGING AMBIENT TEMPERATURE RANGE: 32°F (0°C) - 104°F (40°C)
• OPERATING AMBIENT TEMPERATURE RANGE: 14°F(-10°C)-104°F(40°C)
• ALWAYS KEEP THE CHARGING PORT COVER CLOSED WHEN NOT ACTIVELY CHARGING
THE PRODUCT.
• DO NOT USE THIS PRODUCT IF THE FLEXIBLE POWER CORD OR OUTPUT CABLE IS
FRAYED, HAS BROKEN INSULATION , OR ANY OTHER SIGNS OF DAMAGE.
• CHECK THAT THE CHARGER MODEL NUMBER ON THE CHARGER LABEL MATCHES
THE CHARGER MODEL NUMBER LISTED ABOVE.
• CHECK THAT THE CHARGER LABEL IDENTIFIES THE CHARGER AS COMPATIBLE WITH
YOUR JETSON MODEL. YOU CAN FIND YOUR JETSON MODEL’S NAME AND SKU ON A
LABEL ADHERED TO THE TOP, SIDE, OR UNDERSIDE OF THE PRODUCT’S FRAME OR
STANDING DECK.
CHARGER
CHARGER
CABLE
CHARGER
CORD
CHARGING
INDICATOR
LIGHT
CHARGING CHARGING
COMPLETE
CHARGING
INDICATOR LIGHT
ON THE CHARGER:
RED
ILLUMINATION
GREEN
ILLUMINATION
*DEPENDENT ON THE DATE OF PRODUCTION OF YOUR UNIT, THE CHARGING
TIME MAY BE APPROXIMATELY 3 OR 4 HOURS. ALWAYS USE THE INDICATOR
LIGHT ON THE CHARGER TO DETERMINE WHEN CHARGING IS COMPLETE.