Jetson Warren - Installing the Seat

2
26
1. PULL OPEN THE LATCH ON THE SEAT CLAMP.
2. LOCATE THE "MINIMUM INSERTION" MARK NEAR
THE BOTTOM OF THE SEAT POST.
3. HOLD THE SEAT IN POSITION ABOVE THE
BIKE, WITH THE WIDEST PART OF THE SEAT
AT THE REAR.
4. LOWER THE SEAT POST DOWN THROUGH THE
CLAMP AND INTO THE SEAT TUBE UNTIL THE
MINIMUM INSERTION MARK IS BELOW THE CLAMP.
TROUBLESHOOTING: IF THE POST CANNOT
FIT THROUGH THE CLAMP, WIDEN THE CLAMP
OPENING BY TURNING THE CLAMP KNOB
COUNTERCLOCKWISE WITH THE 5MM ALLEN KEY TIP
OF THE MULTITOOL.
1.5 Installing the Seat
SEAT CLAMP LATCH
SEAT CLAMP KNOB
OPPOSITE SIDE;
NOT SHOWN
5MM ALLEN KEY
SEAT POST
"MINIMUM INSERTION" MARK
SEAT CLAMP
SEAT TUBE