1. PULL OPEN THE LATCH ON THE STEM CLAMP.
2. LOOSEN THE CLAMP KNOB BY TURNING IT COUNTERCLOCKWISE.
3. RAISE OR LOWER THE STEM UNTIL THE HANDLEBAR IS AT THE DESIRED HEIGHT.
IMPORTANT: NEVER RAISE THE HANDLEBAR SUCH THAT THE "MINIMUM
INSERTION" MARK COMES INTO VIEW ABOVE THE CLAMP.
4. WHILE HOLDING THE HANDLEBAR IN PLACE, RETIGHTEN THE CLAMP KNOB BY
TURNING IT CLOCKWISE.
TROUBLESHOOTING: IF YOU CANNOT OPEN OR CLOSE THE CLAMP
LATCH, THE KNOB MAY BE TOO TIGHT. LOOSEN THE KNOB BY TURNING IT
COUNTERCLOCKWISE FOR ½ ROTATION AT A TIME UNTIL YOU CAN UTILIZE
THE LATCH.
5. CHECK THAT THE HANDLEBAR IS SECURE: USE YOUR HAND TO PUT DOWNWARD
PRESSURE ON THE HANDLEBAR. IF THE STEM SLIPS DOWN INTO THE STEM
TUBE, BRING THE HANDLEBAR BACK TO POSITION AND TIGHTEN THE CLAMP BY
FURTHER TURNING THE KNOB CLOCKWISE.
2.1 Adjusting Handlebar Height
2. Preparing to Ride
STEM CLAMP
LATCH
STEM
STEM CLAMP KNOB
STEM CLAMP
To Next Page
Loading...
