2.5 Tire Inlation & Pressure
BEFORE YOUR FIRST RIDE, YOU WILL NEED TO ADD AIR
TO YOUR TIRES TO BRING THEM TO THE RECOMMENDED
PRESSURE OF 20 PSI POUNDS PER SQUARE INCH. USE A
GAUGE TO CHECK THAT YOUR TIRE PRESSURE IS AT 20 PSI
PRIOR TO EVERY RIDE.
TO ADD AIR:
1. REMOVE THE DUST CAP FROM THE TIRE VALVE ON ONE
WHEEL BY TWISTING IT OFF COUNTERCLOCKWISE. SET
IT ASIDE.
2. FOLLOW THE MANUFACTURER’S INSTRUCTIONS ON
YOUR AIR PUMP TO INSERT AIR INTO THE TIRE. CHECK
PERIODICALLY WITH A GAUGE AND CONTINUE ADDING
AIR UNTIL YOU REACH 20 PSI.
3. REMOVE THE AIR PUMP AND REPLACE THE DUST VALVE
BY TWISTING IT ON CLOCKWISE.
4. REPEAT WITH THE OTHER TIRE.
IMPORTANT: ONLY USE A MANUAL AIR PUMP TO
INFLATE THE TIRES ON YOUR WARREN. NEVER USE AN
AIR COMPRESSOR; DOING SO MAY CAUSE THE TIRE
TUBES TO POP.
TIRE VALVEDUST CAP
To Next Page
Loading...
