28
- Firewall IPv4
From the Web UI, click Settings > Advanced Router > Firewall IPv4. You may set up
firewall rules to protect your network from virus and malicious activity on the Internet.
Firewall Switch – To set up Port Blacklist and Port Forwarding, turn Firewall Switch ON.
If Firewall Switch is OFF, both Port Blacklist and Port Forwarding settings are not active.
Port Blacklist – You can block outbound forward packet by setting up a rule in the
blacklist. To set up the rule,
1. Turn ON Port Blacklist.
2. Press Add to create a line to setup a rule.
3. Enter the name of the rule you want to set up.
4. Enter IP address of the site you want to restrict outbound forward packet.
5. Enter Port number of the outbound forward packet.
6. Select Protocol and Status ON/OFF: ON means the rule is in active. OFF means the
rule is not active.
7. Press OK to complete set up, then press Save Changes.
To Next Page
Loading...
