11
Operate the left joystick to make the drone ascend and then release the joystick. The drone will
hover at the height you release the joystick.
Put the drone directly in front of the remote control, with the drone facing forward, calibrate it
horizontally after pairing, and short press the headless mode button (as shown in Figure 1). When
the drone enters headless mode, the remote control emits a drop sound, the lamp 1 of the remote
control is always on (as shown in Figure 2), and the LCD of the remote control displays the icon of
headless mode. To exit headless mode, press the headless mode button again to exit. The lamp 4
of the remote control goes off. The headless mode icon of the LCD of the remote control disappears.
Make sure the operator is facing in the same direction from start to finish, the same direction as
when the drone takes off.
At this point, no matter which direction the drone is facing, the operator will move the Joystick in the
direction and move back, and the drone will move back towards the operator.
⑤Hovering
⑥Headless Mode
Figure 1 Figure 2
Headless mode
Remote control light 1
is always on
Light1 Light2 Light3 Light4
Forward Backward
Forward
Backward
Backward
Forward
Email: nostech1@hotmail.com
To Next Page
Loading...
