13
OUTDOOR FLIGHT OF THE DRONE
1.Pairing Remote Control with Drone
2.Manually Calibrate the Geomagnetism
(for example, in flight,
off-course/fixed point erratic spinning)
①Long press the power button of the drone (as shown in Figure 1), the drone starts up, and front
indicator lights flash quickly. At this time, drone is testing the gyroscope. After waiting for 3-4
seconds, the lights of the drone flash alternately (as shown in Figure 2).
②Turn on the switch of the remote control (as shown in Figure 3). After a beep sound from the
remote control, the frequency will be adjusted. The fourth indicator light of the remote control will
glow constantly (as shown in Figure 4).
③After pairing, the front blue light is glowing constantly and the rear red light is slowly flashing (as
shown in Figure 5), and then the drone will start satellite searching. (If the magnetic field
interference is too large after frequency adjustment, the drone light display will flash three times
and pause once(As shown in Figure 6), it is necessary to calibrate geomagnetism. Please refer to
page 13 “Manually Calibrate Geomagnetism” for calibration.)
Calibration of geomagnetic (compass): short press the “one-key calibration compass” button (as
shown in Figure 1) for about 3 seconds indicator lights,of the drone starts flashing rapidly (as
shown in Figure 2), with three quick flashes and one pause, indicating that the drone is ready to be
calibrated. Then pick the drone and rotate Rotate horizontally clockwise 3 times (as shown in
Figure 3). Red lights becomes constant and blue lights are still flashing.(as shown in Figure 4), at
the same time the remote control beeps indicates that player needs to rotate the drone vertically in
clockwise for 3 times. (as shown in Figure 5), When the blue lights turn to constant, red lights flash
again (see Figure 6) and there are beep sounds from the remote controller, it means the
geomagnetism calibration is completed and player just need to wait for satellite signal now. GPS
signal light on the remote controller glows constantly when satellites searched is over 8.
Figure 2Figure 1 Figure 3
Figure 5Figure 4 Figure 6
Power Switch
Light1 Light2 Light3 Light4
One-key Calibrate
the compass
Figure 2Figure 1 Figure 3
Figure 5Figure 4 Figure 6
Email: nostech1@hotmail.com
To Next Page
Loading...
