JLG 2632ES User Manual

Operation and Safety Manual
Original Instructions, Keep this manual with the machine at all times.
ANSI
®
AS/NZS
Models
1930ES/
2032ES/2632ES/
2646ES/3246ES
USA Built - S/N 0200239382 to Present
China Built - S/N B200020297 to Present
Mexico Built - S/N M200000100 to Present
Belgium Built - S/N 1200025021 to Present
P/N - 3121655
July 20, 2018 - Rev H

JLG 2632ES Specifications

General

Gradeability	25%
Platform Width	30 in
Power Source	Electric
Platform Capacity	500 lbs
Turning Radius - Inside	0 in
Batteries	4 x

Summary

FOREWORD

SECTION 1 - SAFETY PRECAUTIONS

1.1 GENERAL

Outlines necessary precautions for proper and safe machine usage and maintenance.

1.2 PRE-OPERATION

Details pre-operation checks, training, and workplace inspection requirements.

Trip and Fall Hazards

Safety measures to prevent falls from the platform and during entry/exit.

Electrocution Hazards

Safety procedures related to electrical hazards and minimum approach distances.

Tipping Hazards

Precautions to prevent machine tipping due to ground conditions or operation.

Crushing and Collision Hazards

Guidelines to avoid crushing and collision during operation.

1.4 TOWING, LIFTING, AND HAULING

1.5 MAINTENANCE

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION & INSPECTION

2.1 PERSONNEL TRAINING

Emphasizes the necessity of trained personnel for operation and maintenance.

2.2 PREPARATION, INSPECTION, AND MAINTENANCE

Covers periodic machine inspections and maintenance recommendations.

Pre-Start Inspection

Specific checks required before each day's operation.

Walk-Around Inspection

Lists items to inspect during a walk-around of the machine.

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION

3.1 GENERAL

3.3 OPERATING CHARACTERISTICS AND LIMITATIONS

3.4 PLATFORM LOADING

3.5 BATTERY CHARGING

Instructions and safety for charging machine batteries.

3.6 MDI (MULTIFUNCTION DIGITAL INDICATOR)

Explains the Multifunction Digital Indicator (MDI) and its functions.

3.7 GROUND CONTROL STATION

Describes the ground control station, controls, and indicators.

3.8 PLATFORM CONTROL STATION

Details the platform control station layout and component functions.

3.9 PLATFORM OPERATION

Covers procedures for raising and lowering the platform.

3.10 PLATFORM DECK EXTENSION

3.11 PLATFORM RAILS FOLD-DOWN PROCEDURE

3.12 PARKING AND STOWING

3.15 TOWING

SECTION 4 - EMERGENCY PROCEDURES

4.1 GENERAL

Provides information on emergency procedures and systems.

Manual Descent

Explains manual lowering of the platform in case of power failure.

4.2 EMERGENCY OPERATION

Details emergency operation procedures and use of ground controls.

Operator Unable to Control Machine

Platform Caught Overhead

Righting of Tipped Machine

Post-Incident Inspection

4.3 INCIDENT NOTIFICATION

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE

6.17 OPERATING SPECIFICATIONS

Lists key operating specifications for different models.

Dimensional Data

Motors

Batteries

Battery Charger

Battery Charger/AC Inverter

Capacities

Tires

Critical Stability Weights

Lubrication

6.18 OPERATOR MAINTENANCE

Outlines daily maintenance tasks for machine operators.

Scissor Arms - Safety Prop

Oil Check Procedure (1)

Lower (2) & Upper Slide Pads (3)

6.19 TIRES AND WHEELS

6.22 DIAGNOSTIC TROUBLE CODES (DTC)

Reference for diagnostic trouble codes read from the MDI.