SECTION 1 - SAFETY PRECAUTIONS
3121740 1-11
• When moving the machine, the operator must limit travel
speed according to conditions of ground surface, conges-
tion, visibility, slope, location of personnel, and other fac-
tors.
• Exercise extreme caution at all times to prevent obstacles
from striking or interfering with operating controls and per-
sons in the platform.
• Ensure that operators of other overhead and floor level
machines are aware of the aerial work platform’s presence.
Disconnect power to overhead cranes. Barricade floor area
if necessary.
• Do not operate over ground personnel. Warn personnel not
to work, stand, or walk under a raised platform. Position
barricades on floor as necessary.
1.5 MOVING, LIFTING AND REPOSITIONING
General
• Never allow personnel in platform while moving, lifting
or repositioning the machine.
• This machine shall not be towed by a vehicle.
• Do not move assembled unit on wheels over soft or
uneven surfaces, or over obstructions, bumps, debris,
etc.
• Disassemble unit to transport over uneven or sloped
ground, or in a vehicle.
• Ensure platform is fully retracted and completely empty
of tools prior to disassembly, lifting or hauling.
• Refer to the Machine Operation section of this manual
for lifting information.
Additional Safety Information
• Do not use machine as ground for welding.
To Next Page
