What to do if ropes are worn or broken on JLG LiftPod FS80 Lifting Systems?
If the ropes are worn or broken, or the machine is 5 years old, deliver the unit to an Authorized JLG Service Center for replacement.
How to fix a JLG Lifting Systems machine that does not wheel properly?
If your JLG Lifting Systems machine isn't wheeling properly, it might be because the retractable swivel castor isn't properly deployed. Ensure there's no load on the platform or base, then lift the castor deploy handle on the front of the base. The castor should deploy, lifting the front of the machine. If the castor is damaged, replace it.
What to do if my JLG LiftPod FS80 platform doesn't lift up from the bottom, but the motor starts?
If the JLG Lifting Systems platform motor starts but doesn't lift from the bottom, the driveshaft interlock may be engaged. Push the cordless drill on the driveshaft down firmly to disengage it. If using a powerpack, check it's correctly fitted to the platform, the latch is down, and the drive shaft is connected to the carriage drive shaft. Also, ensure a load greater than 50kg is in the platform and the lifting ropes are tight. If the latch hasn't released, lower the loaded platform slightly and try lifting again.
What to do if my JLG LiftPod FS80 platform will not move when in elevated position, but the motor starts?
If the JLG Lifting Systems platform doesn't move when elevated but the motor starts, the driveshaft interlock might be engaged. Push the cordless drill on the driveshaft down firmly to disengage it. If using a powerpack, ensure it's charged, correctly fitted, fully down, and latched. If the drive shaft malfunctions, lower the platform using the manual descent procedure and refer to an Authorized JLG Service Center.
Why does my JLG LiftPod FS80 machine rock slightly side to side?
If your JLG Lifting Systems machine rocks slightly side to side, it could be because the support surface isn't level. Only use the machine on firm and level surfaces. Also, ensure both adjustable feet are in contact with the supporting surface, and adjust them so the machine is level.
General| Steering | Manual |
|---|---|
| Power Source | 12V Battery |
| Machine Width | 30 in |
| Machine Length | 42 in |
| Horizontal Reach | 0 ft |
| Tire Type | Solid |
Explains the meaning and use of safety alert symbols and signal words.
Records the history of revisions made to the manual.
Outlines necessary precautions for proper and safe machine usage and maintenance.
Details pre-operation requirements including operator training and inspections.
Provides guidelines and warnings for operating the machine safely.
Specifies requirements for competent personnel operating and maintaining the machine.
Covers the necessary information for machine readiness and maintenance.
Details the procedure for performing a daily walk-around inspection.
Provides general information and responsibilities regarding machine operation.
Describes the components and configuration of the JLG LiftPod machine.
Details the steps for getting started and assembling the machine.
Covers powerpack operation, charging, and status lights.
Explains steps to take in case of an emergency situation during operation.
Details the use of the manual descent crank for emergencies.
Specifies requirements for notifying JLG Industries of incidents involving the product.
Provides operating specifications and maintenance information.
Lists assembled machine specifications including weight, height, and wind speed.
Details the weights of various machine components for assembly and transport.
Outlines general safety precautions to be observed during machine maintenance.
Provides information for personnel responsible for machine operation readiness and maintenance.
Lists preventive maintenance and inspection checks for various machine areas.
Contains information for locating and correcting most operating problems.
Provides a table for recording inspection and repair details.
To Next Page
