Joerns EasyCare Bed - Leg Positioner and Servicing; EasyLift Leg Positioner Operation; Servicing Guidelines; Part Numbers

12
Joerns® Bed Frames
EasyCare®
©2023 Joerns Healthcare • 6110444 RevA • 000547
Warning: Possible Injury or Death. Do not apply
any width expansion accessory kit to a Joerns bed
equipped with the Care-Fit integrated width expansion
feature. Failure to comply may cause the bed to
become unstable, leading to a possible injury or
equipment failure.
Warning: Possible Injury. Ensure side assist fastener
is hanging down when not in use (Figure 28). Ensure
the side assist fastener is not trapped and positioned in
a manner that the fastener would not come into contact
with exposed skin.
EasyLi Leg Positioner Operation
1. To raise: The knee should be in a raised position
prior to adjusting the leg positioner. Grasp the
bed’s foot deck and raise to the desired position
(Figure 29).
2. To lower: Grasp the foot end of the bed’s deck
and raise ½-inch to ¾-inch above present notch,
then lower gently; or, grasp the foot end of the
bed deck, raise to the highest position, and lower
gently.
3. Lower the knee section with the pendant or sta󰀨
control. Note: The EasyLift should be lowered
before the knee section.
Caution: Be careful not to damage power cord when
moving or placing bed. After placing bed in service,
monitor power cord positioning carefully to prevent
damage as you fully operate all bed functions.
Caution: When power cord is not plugged into a wall
outlet, place it on sleep surface to prevent it from
contacting oor. This will help prevent cord damage
when transporting bed.
Caution: If a power cord is damaged, remove bed
from service until repairs are performed.
Figure 29
Servicing
Warning: Never perform maintenance with a resident/
patient on or near the device. Only qualied personnel
should attempt to perform maintenance on this bed.
Failure to properly follow all warnings and instructions
may result in personal injury or damage to the device.
Failure to properly care for the device may decrease
the device life and increase the need for maintenance.
Service Parts List available upon request. The actuators
and control box contain no serviceable items.
Part Numbers
Pendant: 11017333
Power Cord: 11013795
Power Cord and Grounding Connectors
Inspection of power cord and grounding connectors
(if present) should be conducted on a yearly basis to
ensure e󰀩cient bed operation.
1. Check the power cord to make sure it has not been
damaged. If the power cord needs replacement due
to damage, remove the bed from use/service until
the power cord has been replaced.
2. Check the grounding connectors (if present)
to ensure they remain intact and are securely
fastened to their intended connection point.
Figure 28