Jofemar Vision ES-PLUS - Product Dispenser Channels

Vision Es-Plus // Vending
MNP141GBV00 Date: 2011/04/29 Rev. 0 PAGE 13 OF 24
4.2. Product dispenser channel
There are three types of different product dispensers. Depending on the type of product
to be served, you can interchange these channels, offering a wide range of
combinations. A maximum of 10 dispenser channels can be added to each tray.
Fig. 13 Fig. 14 Fig. 15
Ref. code 8210061 (Fig. 22) 8210062 (Fig. 23) 8210063 (Fig. 24)
Motor power supply 12 Vcc 12 Vcc 12 Vcc
Max. power
consumption
3 w 3 w 3 w
To properly dispense a product, the dispenser motor operation voltage has to be
programmed on the master machine to ensure the most appropriate dispensing speed
for each product.
4.3. Control card
Fig. 16
CONNECTION CONTROL CARD
A. Transformer secondary and relays K. (Not in use)
B. Connection elevator L. Door microswitch connection
C. Connection tray motors M. RS-232 port connection (1)
D. (Not in use) N. RS-232 port connection (2)
E. Connection tray motors Ñ. (Not in use)
F. (Not in use) O. Set slave number
G. (Not in use) P. (Not in use)
A B C D E
F
P G
Q
R H
I
S
O Ñ N T M L K J