Vision Es-Plus // Vending
MNP141GBV00 Date: 2011/04/29 Rev. 0 PAGE 17 OF 24
5. Installation and start up
5.1. Installation
Do not install the machine near active heat sources (heaters, radiators, etc.). Avoid
obstructing the grids located at the front of the cabinet to ensure air circulation inside,
where the cooling unit motor is located (if the machine has one). Leave a distance of at
least 7 centimetres between the back of machine and the wall or other items .
In 24 hour vending facilities, make sure that the hot air coming out of the machine at the
back can be easily discharged, i.e., that the machine is properly vented at the back.
Efficient removal of hot air significantly reduces the power consumption of your machine
and hence your electricity bill.
F IMPORTANT: It is important for the machine to be level, as it should operate in
a vertical position, both laterally and front-to back, placed so the mains plug is readily
accessible and with a maximum tilt of 5% (~2°). This will also prevent noise and
vibration and will extend the cooling unit service life.
5.2. Start up
As a safety measure to avoid damaging the cooling circuit (if the machine has one), wait
to connect the machine to mains for 2 hours after finishing unpacking and installing the
machine.
5.3. Restocking machine trays
Open the machine door, press the tray anchoring system (on the side), slide out the tray
to be restocked and place the products in their channel until all of the machine’s trays
have been restocked.
Fig. 21
To Next Page
Loading...
