Vision Es-Plus // Vending
MNP141GBV00 Date: 2011/04/29 Rev. 0 PAGE 2 OF 24
F WARNING!
Read the following instructions carefully before using your machine:
? Remove plastic plugs from bottom of machine and place it on the floor before
opening and unpacking.
? When dis carding packaging material or an old machine, please consult about
recycling.
? Since the machine has a cooling unit, it should be transported in vertical position
and it should not be connected to mains until 2 hours have elapsed after concluding
the unpacking and installation process.
? Before connecting to mains, make sure that the power supply characteristics
coincide with those of the machine.
? The power cable plug should be installed so the machine can be easily
disconnected from mains.
? Place a rubber protection around the power cable in the slot of the lid of the cable
winding recess.
? Do not burn or throw away the battery. Batteries should be disposed of in
accordance with local laws and regulations and may be recyclable.
? Protect the machine against humidity, dust, dirt, etc. You should particularly avoid
any obstruction of the ventilation grids.
? Do not clean the machine with concentrated products as they may attack the
painted and wood surfaces and alter the colour.
? Frequent cleaning, can prevent breakdowns and extend the machine's service life.
? The machine should be installed in a vertical position, with a maximum back to
front or lateral tilt of 5% (~2°).
? If you need to replace the power supply cable, please replace it with the
appropriate one for your country:
If the power cable is damaged, it should be replaced by the manufacturer or
after sales service or similar qualified personnel to prevent hazards.
Jofemar S.A.
Ctra. de Marcilla Km.2, 31350 PERALTA. Navarra, SPAIN.
http: // www.jofemar.com Tel. +34 948 75 12 12 Fax +34 948 75 04 20
To Next Page
Loading...
