John Bean VPI SYSTEM II - Table of Contents

Page 3
John Bean VPI System II Operators Manual
TABLE OF CONTENTS
General Safety Instructions Page 2
1.0 Introduction Page 4
1.1 Safety Notice Page 4
1.2 Balancer Application Page 4
1.3 Specifications Page 5
1.4 Balancer Features Page 5
1.5 Standard Accessories Page 6
1.6 Optional Accessories Page 6
1.7 Dimensions Of The Machine Page 7
1.8 Installation Area Page 7
1.9 Installation Instructions Page 7
2.0 Shaft Adapter Installation Page 7
2.1 Wheel Guard Installation Page 8
2.2 Electrical Installation Page 8
3.0 Terminology Page 9
4.0 Balancer Operation Page 10
4.1 Inspection Check list Page 10
4.2 Wheel Mounting Page 10
4.2.1 Mounting of Standard Wheels Page 10
4.2.2 Mounting of Light Truck Wheels Page 11
4.3 Mode Selection Page 11
4.3.1 Weight Placement Modes Page 11
4.4 Selecting Operator Preferences Page 12
4.4.1 Fine Balance Mode Page 12
4.4.2 Ounce /Grams Conversion Page 12
4.4.3 Inch/Millimeter Conversion Page 12
4.4.4 Selection of Operator A/B Page 12
4.4.5 Optional Weight Miser Operation Page 12
4.5 Entering Rim Parameters Page 14
4.5.1 Distance and Diameter Entry Page 14
4.5.2 Rim Width Entry Page 14
4.5.3 Manual Parameter Entry Page 14
4.6 Correcting the Imbalance Page 15
4.7 Verifying Results Page 15
4.8 Vibration Problems Page 15
4.9 Weight Call-Back Program Page 15
5.0 Matching Program Page 16
6.0 Optimization Program Page 18
7.0 Alu-S Program Page 19
8.0 Spoke Mode Page 20
9.0 Split Weight Mode Page 21
10.0 User Shaft Calibration Page 22
11.0 Distance/Diameter Gauge Calibration Page 23
12.0 Explanation of "F" Codes Page 24
13.0 Maintenance Page 24
14.0 Trouble Shooting Page 24