Type of Field
Device
Type of Input/
Output
Termination Diagrams
Relay Output
(Switch High,
Externally
Sourced)
RO
IP20 Covers Accessory Kit
Kit contents
Prerequisites:
Before installing the IP20 Covers Accessory Kit, all
wiring must be secured to the stress brackets as
illustrated below.
The following procedure describes how to install the
IP20 Covers Accessory Kit to the ATC.
1. Attach the IP20 cover to the lower part of the ATC,
and tighten the screws.
2. Attach the IP20 cover to the upper part of the ATC,
and tighten the screws.
ATC1510 Advanced Terminal Unit Controller Installation Guide12
To Next Page
Loading...
