CK721-A Network Controller Hardware Installation
24-10025-237 Rev. –
11
Panel
To set the CK721-A IP address and netmask, preferred primary comm path:
1. From the CK721-A Main menu, select Panel and press <Enter>.
2. Type the panel name and IP address. The IP address must be unique.
The default netmask is 255.255.255.0. Modify the netmask default value as needed.
3. Enter a Primary Host IP address that matches the IP address of the server. Modify the
netmask default value (Class “C”) as needed. The Alternate Host IP address is not currently
used.
4. Set the Preferred Primary Comm Path to Y.
5. Set the Network Polling [LAN] setting which specifies the frequency (in seconds) that the
CK721-A panel polls the P2000 server during LAN connections. The recommended value is
30 seconds.
The Network Polling [Dup] value is not currently used.
6. Configure the port numbers. See Table 6 on page 10 for default values.
7. After these values are entered, use the arrow keys to select Save and press <Enter>.
8. A message appears informing you the record has been saved. Press <Esc> to return to the
CK721-A Main menu.
9. From the CK721-A Main menu, select Write Flash. Panel will reboot.
Network Polling [LAN] Recommended value: 30 seconds.
Network Polling [Dup] N/A
Download Port Number Default value: 41014.
Upload Port Number Default value: 41013.
Priority Port Number Default value: 41012.
Table 6: Required Settings - Panel Menu
Setting Value (Direct Connect)
To Next Page
Loading...
Need help?
General
