6139716-UIM-A-0422
Johnson Controls Ducted Systems 19
Section XIV: Start-up sheet
Residential Air Handler with Electric Heat
Correct start-up is critical to customer comfort and equipment longevity
Other switches
(check all that apply)
Blower type
and set-up
Total external static pressure
Supply Return
Condensate trap is primed with water
Filter size
Unit is level Duct connections are complete :
Condensate drain is connected correctly (refer to installation manual)
Filters installed
New construction Horizontal Left
Horizontal Right
Ground connected
Start-up technicianCompany name
208 VAC 230 VAC 460 VAC
Line voltage measured (VAC)
Supply static (in. W.C.) Supply air dry bulb temperature
Return air dry bulb temperature
Temperature drop
1 2 3 4 5
Outside air dry bulb temperature
Return air wet bulb temperature
Supply air wet bulb temperature
Return static (in. W.C.)
Electrical connections and inspection (complete all that apply)
Continued on next page
Variable speed
ECM
Thermostat wiring is complete
Low voltage value between R and C at control board (VAC)
AC HP 80%40% 100%NOYES
Airflow setup
HUMIDISTAT AC/HP CONT FAN
Name Address
City
State or province
Daytime phone
Zip or postal code
Unit model number Unit serial number
Transformer wired correctly for primary supply voltageWires and electrical connections inspected
Unit location and connections (check all that apply)
General information (check all that apply)
Start-up date
Filters
Owner information
Equipment data
Low cool
High cool
Delay
Stage 1 kW
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1
0 / 1 0 / 1
Standard ECM
(circle 0 or 1)
1 2 3 4 5
1 2 3 4 5
HP heating/cooling Y1
Electric heat speed
Continuous fan speed
Heat kit selection
Heat
Retrot
Upow
Downow
Number of lters
Thermostat cycle rate or heat anticipator adjusted to Installation Manual specications
60%
1 2 3 4 5
HP heating/cooling Y/Y2
To Next Page
Loading...
Need help?
General
