Johnson Controls MAHP18B21S - Figure 7 Duct Attachment; Figure 6. Horizontal Suspension

PMGB0406B rev.1
14
Dimension in Inches
Air Handler Cabinet
Size
XH
17-1/2 Width-Short H 21 41
17-1/2 Width-Short H 21 47-1/2
21 Width –Short H 21-1/2 51-1/2
21 Width –Short H 21-1/2 55-3/4
24-1/2 Width 21-1/2 55-1/2
Figure 6. Horizontal Suspension
Duct Flanges
Three duct À anges are provided to assist in positioning and attaching duct work to the air handler. These À anges are
included in the unit parts bag. With the screws from the parts bag, install one of the duct À anges. Duct À anges have
holes on both legs with one leg longer than the other. You can use the longer leg to mate against the air handler
so that different thicknesses of duct board are made À ush with the outer surface of the air handler. Repeat the
procedure for the other two À anges. Refer to Figure 7. If you do not use the À anges, you may discard them.
A0445-001
DUCT FLANGES
(Shipped in bag with unit)
Figure 7 Duct Attachment
(Ins)DX-Kit4e-rev1.inddC-14
(Ins)DX-Kit4e-rev1.inddC-14
2016/11/2515:32:21
2016/11/2515:32:21