24-10515-21 Rev. – 2-1
Chapter
2
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2010 Johnson Controls, Inc.
CONFIGURING P2000 CENTRAL SERVER
Prior to configuring the central server, install the P2000 prerequisites and software (see the
P2000 Server/Workstation Software Installation Manual for details) and backup the
databases.
The steps within this section will tell you how to:
Assign a new Microsoft
®
Windows account to the MS SQL Services
Configure the central site’s database server as Distributor and Publisher
Establish the P2000 Publications
Create snapshots for all P2000 Publications
Use the following tables for reference d
uring P2000 Central and Regional Sites
configuration:
Table 2-1: Central Site Settings
Item Factory Settings Customer Settings
P2000 Server name* CENTRAL
Windows account name** psqlserver
Windows password Master1
SQL server name* CENTRAL
SQL administrator account** sa
SQL administrator account password Master1
Replication Set Id
entity Range*** 10,000,000 to
20,000,000
* The name has to be unique within the Enterprise system.
** Choosing different settings may impact the setup of your
server. It is recommended that you use the factory
settings, or contact Technical Support for assistance.
***Each ID range should be unique within the Enterprise
system and cannot be re-used. If you need to re-assign
the server’s ID range, use a new range.
To Next Page
Loading...
