Table 2-2: Regional Site Settings
Item Factory Settings Customer Settings
P2000 Server name* ORANGE
Windows account name**
(the same as for the central server)
psqlserver
Windows password
(the same as for the central server)
Master1
SQL server name* ORANGE
SQL administrator account**
(the same as for the central server)
sa
SQL administrator account password
(the same as for the central server)
Master1
Replication Set Id
entity Range*** 20,000,000 to
30,000,000
* The name has to be unique within the Enterprise system.
** Choosing different settings may impact the setup of your server
. It is recommended that you use the factory
settings, or contact Technical Support for assistance.
***Each ID range should be unique within the Enterprise system and can
not be re-used. If you need to re-assign
te server’s ID range, use a new range.
Configuring P2000 Central Server Enterprise Configuration
2-2 24-10515-21 Rev. –
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2010 Johnson Controls, Inc.
NOTE
The procedures described in this chapter are to be performed starting with
a clean P2000 installation. The P2000 Enterprise Configuration cannot be
set up properly through an upgrade from earlier versions of P2000
software.
SQL SERVER LOGIN ACCOUNT
During replication, SQL Server and SQL Server Agent cannot run as “local system,” but
require a separate account on all participating servers. To create it, follow the steps below.
Creating the “psqlserver” Account
The steps for creating and configuring the “psqlserver” account vary depending on
whether or not the P2000 server is on the domain.
If your P2000 server is no
t on the domain, follow the steps below. For instructions to
be used on a P2000 server that is on the domain, see page 2-5.
To Next Page
Loading...
