Johnson Controls P2000 - Rules for Data Merging

Enterprise Configuration Merging Data Between Sites
24-10515-21 Rev. – 3-17
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2010 Johnson Controls, Inc.
 From the database maintenance window, select Validate Digital
Signature and click the Perform button.
 In the Validate Digital Signature window, click the button Select All and
then the Perform button.
 P2000 will now perform the operations on the database. This may take a
few minutes. When the process is completed make sure there are no
invalid signatures. Click Cancel to close the window.
 To close the Database Maintenance window, click Exit.
13. Verify that the P2000 regional server is fully operational and perform
download to all panels.
Refer to the P2000 Software User Manual for detailed instructions.
RULES FOR DATA MERGING
When merging the data from the P2000 regional server into the P2000 central server, the
following rules are applied:
 Records that already exist in the P2000 central server will not be modified, as they
are currently active within the existing P2000 Enterprise.
 Only the records explicitly designated to be merged will be merged into the central
database.
 Conflicts of badge numbers (that is, if a badge number is already assigned to another
cardholder) are always resolved assuming that the P2000 central server has the
correct information.
As a consequence of the above rules, it is recommended that you check the cardholder/badge
security settings before the subscription is established, or before a new P2000 regional server
becomes the active P2000 server for the regional system.
In addition, any configuration changes between backing up the P2000 regional server and
completing the data subscription, have to be re-entered into the P2000 system.