Johnson Controls P2000 - Connecting to the SQL Server; Establishing Subscriptions

Configuring P2000 Regional Server Enterprise Configuration
4-4 24-10515-21 Rev. –
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2010 Johnson Controls, Inc.
 After the reboot:
1. Log in with the psql
server login name.
2. Stop the P2000 Services and quit their monitoring.
CONNECTING TO THE SQL SERVER
You need t o :
 Connect to the SQL Server
 Assign a password to the SQL Server’s administrator account
Instructions are the very similar to those for the central
server. This time, however, you will
be logging in to the regional server. Please refer to the “Connecting to the SQL Server”
section on page 2-8.
If this is not a clean install (install on servers with
empty databases), it is recommended that
after the data of the P2000 regional server has already been merged to the P2000 central
server, you un-install and re-install the software on the P2000 regional server as follows:
 Back up current database in P2000 regional server
 Note the P2000 Installation Key and Registration/Option Keys
 Follow the standard un-install instructions as found in the P2000 Server/Workstation
Software Installation Manual.
 During the un-install delete the databases, but not delete any BadgeImages or
Pegasys accounts
 Re-install P2000 and re-register the software using the Installation Key and
Registration/Option Keys
ESTABLISHING SUBSCRIPTIONS
Establish the subscriptions from their respective regional sites. Procedures described in this
section need to be performed from each regional site.
NOTE
Establish only one Subscriber at a time.
!
CAUTION
Before proceeding, stop all P2000 Services on the regional site and quit
their monitoring.
 To stop all P2000 Services:
1. From the P2000 main menu, select System>Se
rvice Control.