Configuration VPN/DSL Security Option
2-2 24-10618-155 Rev. A
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
VPN Router LAN IP Address
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
HARDWARE INSTALLATION AND CONFIGURATION
The hardware listed below is not provided in the P2000 hardware package. In order to
implement the VPN/DSL Security Option, you must purchase the necessary equipment from
your local computer supplier or by contacting the manufacturer directly.
The VPN/DSL Security Option can b
e configured with the Linksys® and/or NetScreen®
routers listed below. Linksys routers are less expensive, but are not National Institute of
Standards and Technology (NIST) certified or Underwriters Laboratories (UL®) compliant.
Select the routers according to your site requirements.
Table 2-2: Required Hardware
Make/Model Description
Combination of two of the following (see
router combination information below):
NetScreen-5XT (NIST Certified)
Linksys BEFVP41
Linksys BEFSX41
VPN Routers with 4-Port 10/100 Switch
You must have one of the following router combinations:
Two (2) NetScreen-5XT routers
One (1) Linksys BEFSX41 (front end) router and one (1) Linksys BEFVP41
(back end) router
One (1) NetScreen-5XT (front end) router and one (1) Linksys BEFVP41
(back end) router
Contact Information: NetScre
en www.juniper.net
Linksys www.linksys.com
To Next Page
Loading...
